Program 2004 tundra remote

Within 40 seconds, Close then open the drivers door. Close then open the drivers door. Within 40 seconds. Insert the key into ignition and leave it in the ignition.

Close the drivers door. Remove the key from the ignition. Within 3 seconds, the power door locks should lock then unlock automatically indicating successful entry into programming mode.

Return to step 1 if the door locks do not cycle at this point or try the alternate procedure listed below. Within 40 second, A. Press the lock and unlock buttons on the remote simultaneously for 1. Immediately after letting go of the lock and unlock buttons, press and hold the lock button by itself. Within 10 seconds, the door locks should lock and then unlock once indicating successful programming.

If the door locks cycle twice, repeat steps A and B in step 6 as the remote was not accepted Repeat steps A and B in step 6 for each new remote. You are currently viewing as a guest! To get full-access, you need to register for a FREE account. Rear Bumper Tailgate handle Radiator replace Tacoma wheels fit?

Remote key and program mode tundra Discussion in ' 1st Gen Tundras ' started by spahnrl , Jul 4, Post Reply. I appreciate some help. Joined: Sep 6, Member: Messages: 1. Made me a little crazy, but I got two new fobs programed. Jtcoll , Sep 6, This thread. JerrySD , Sep 7, I tried both procedures that I found on the internet to get my truck to go into programming mode and nothing seems to work!!! I called the dealership and they did confirm my truck came with keyless entry.

Now what???? JQ3 , May 3, Last edited: May 4, Professional Hand Model likes this. JQ3 , May 4, This is the procedure I used to do my 04DC. Something to think about also, I had trouble with mine the first couple times and it ended up being the drivers door switch was making intermittent contact so it didn't always register that the door was open.

Single and Double Cab Start with the key out of the ignition, drivers door is open, all other doors and trunk closed and drivers door is unlocked. Perform these steps within 5 seconds. Perform these steps within 40 seconds. Close then open the drivers door.

Insert the key into ignition and leave it in the ignition. Close the drivers door. Remove the key from the ignition. Within 3 seconds, the power door locks should lock then unlock automatically indicating successful entry into programming mode.